KNX0008 NAOS 16 fold binary outputs / 8 fold blind actuator 8 modules DINRAIL Vivo
KNX device for independent switching of max. 16 groups of electrical loads (binary output) or independent controlling of max. 8 drives (blind actuator). It has to be used in KNX installations for control of homes and buildings.
(BINARY OUTPUT)
• ON/OFF switching of individual loads or groups of loads
• Configurable as normally open or normally closed switch
• Logical gates and forced mode for each channel
• Manual control by membrane pushbuttons
• Status feedback of output channels through LEDs
• Switching pushbutton manual/automatic mode
• Block function for each channel
• Time scheduling: switching delay for on and off, staircase lighting function with warning signal
• Integration in scenarios
• Operating hours counter configurable via bus
(BLIND ACTUATOR)
• Full up and down run
• Partial run with stop position from 0 to 100% of the length of the run
• Position setting (change during the operation of the preset position)
• Adjust the inclination of the slats (for blinds)
• Integration in scenarios
• Automatic control for protection against direct sunlight
• Automatic control for protection against weather conditions (rain, wind, frost)
Technical data
• Power supply (loads) 230 Vac 50/60 Hz
• Power supply (electronics) 30 Vdc from KNX bus
• Current consumption < 10 mA
• Power consumption < 240 mW