NOTE: THE VALUE OF STATE ROLLER / VENETIAN (1 byte), ENDED THE DOWNLOAD IS DISPLAYED THE FEEDBACK ONLY AFTER A FIRST COMPLETE HANDLING (until it stops)
The blind/switch actuator REG-K/x/x/10 with manual
mode (referred to below as actuator) can
– control blind/roller shutter drives with end position
switch independently of one another,
– switch loads (luminaires) via separate, floating
You can operate each channel either as a blind channel or as two switching channels. In the "Switching" channel operating mode, one blind channel is divided into two equal switching channels. You must change over the channels at the device itself and in the ETS. For further information, please refer to the section "Toggling between the blind and the switching operating mode". You can switch the actuator to manual operation and check that it works even without ETS programming, and you can control the connected loads directly at the actuator in the event of a bus failure. The actuator has a bus coupler. It is installed on a DIN
rail, with the bus connection made via a bus connecting terminal. A data rail is not required.